Atag VA63313ST Benutzerinformation Seite 20

20
Problem and alarm code
The remaining time in the
display increases and skips
nearly to the end of program
time.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
Rattling/knocking sounds
from inside the appliance.
The appliance trips the cir‐
cuit-beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
The washing and drying results are not satisfactory
Problem
Poor washing results.
Possible cause and solution
• This is not a defect. The appliance is working correctly.
• The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
• The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The tableware is not properly arranged in the baskets. Re‐
fer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the appliances
in use.
• Internal electrical fault of the appliance. Contact an Au‐
thorised Service Centre.
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and basket load‐
ing leaflet.
• Use more intensive washing programmes.
• Clean spray arm jets and filter. Refer to "Care and
Cleaning".