Operation - HomeMatic IP HmIP-BWTH24 Installations- Und Bedienungsanleitung

• Press and hold down the control wheel (E) to
open the configuration menu (see fig. 6).
• Select the
and confirm by pressing the control wheel briefly.
7

Operation

After configuration, simple operations are available di-
rectly on the device.
If the wall thermostat is in standby mode, please
press the control wheel (E) once before operation
to activate the device.
• Temperature: Turn the control wheel (E) of the
wall thermostat to the right or to the left to
manually change the temperature. In automatic
mode, the manually set temperature will remain
the same until the next point at which the profile
changes. Afterwards, the defined heating profile
will be activated again. During manual operation,
the temperature remains activated until the next
manual change.
symbol by turning the control wheel
Operation
77