Operating Instructions; Appliance Overview; Start-Up And Operation - Rowi HKH 2000/2/1 ODT PREMIUM Originalbetriebsanleitung

4. Operating Instructions

4.1 Appliance overview

1
2
3
4
5
6
7
1
Control unit
2
Display
3
Ventilation grille
4
Remote control
5
Recessed grip/Stowage
compartment for remote control
6
Main switch
7
Power cable
Fig. 1: Appliance overview
GB
26/48
TIMER "-" BUTTON
Temperature and
timer setting
-
OSCILLATION
Fig.2: Control unit

4.2 Start-up and operation

The appliance can be put into operation
after removing the packaging. Proceed as
follows for this:
1. Make sure the main switch (see Fig.
1, No. 6) is at "0". Then connect the
ceramic appliance to an earthed socket
protected with an earth-leakage circuit
breaker.
2. Switch on the appliance by turning the
main switch to "I". The display lights
up and shows three flashing dots. The
appliance is now in stand-by mode.
All the following settings can be made
via the control unit (Fig. 1, Nr. 1) or via
the remote control provided. Insert a
battery (3 V lithium battery CR2025) in
the remote control.
1. Switch on/off
Press the Power button to quit
Stand-by mode and switch on the
appliance. The set desired temperature
now appears on the display for about 5
seconds. It then switches over to the
current room temperature/heating level.
(Check to ensure the fan functions
without fault and the motor does not
hum.)
MODE
Hating level setting
+
°C
"+" BUTTON POWER
Temperature and
timer setting