Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mod. 0992/0992P
INTRODUCTION
Keep this instruction manual in a safe place; for
any
information
comprehensively dealt with, contact qualified
personnel.
1. SYMBOLS
The warning triangle identifies all explanations
of importance for human safety.
Follow these indications to prevent
accidents!
The numerical symbol, numbers or letters
indicates references to illustrations and
2
parts of the machine like keys, luminous
indicators, etc.
The manufacturer assumes no responsibility for
possible damage/injury in case of:
• Uses not in conformity with the intended
purposes;
• Alteration to the power cord;
• Alteration to any machine part;
•
Use
of
non-original
accessories;
• Repairs made at unauthorised service
centres;
This
product
complies
requirements
established
Directive (2002/96/EC). The affixed symbol
indicates that this electrical or electronic
product should not be thrown in a container
for
household
CATEGORY with references to the types of
appliances listed in Annex 1 of the WEEE
Directive; this product falls into category 2
"Small household appliances".
DO NOT THROW INTO A CONTAINER FOR
HOUSEHOLD WASTE.
Lack of compliance with the above points
render the warranty invalid.
or
problems
not
components
or
with
the
label
in
the
WEEE
waste.
PRODUCT
2. WARNINGS
Do not leave packaging items (plastic bags, expanded
polystyrene, nails, cardboard boxes, etc.) within the
reach of children as they are potentially hazardous.
Before connecting the machine make sure that the
rating plate data comply with those of the power
distribution network.
The power cord should be completely extended (do not
roll up or overlap) and positioned where it is not
exposed to bumps or minor tampering; do not place
near water or other liquids or near heat sources; make
sure it is not damaged (otherwise have it replaced by
qualified personnel).
The use of adapters, multiple outlets and/or extension
cords is not recommended. If it should be necessary to
use them, use products with quality certification
marks (e.g. IMQ, VDE, +s, etc.) and make sure that
the stamped power value is in any case higher than
the absorption (A = ampere) of the connected
appliances.
In case of doubt or uncertainty, have the power
supply system checked by qualified personnel; it must
comply with the requirements set out by the current
safety standards, including:
- effective earthing;
- cross section of conductors sufficient for the
absorption power;
- efficient cut-out device.
Place the machine on a water-resistant surface
(laminate, steel, ceramic, etc.) away from heat sources
(ovens, burners, fireplaces or chimneys, etc.) and in
locations where the temperature does not go below
5°C.
Do not expose the machine to inclement weather or
install it in rooms with high humidity like bathrooms.
If you have to replace parts, contact a dealer or
authorised reseller and only use original spare parts.
Store the packed machine in a place
sheltered from inclement weather that is dry
and moisture free. The temperature should not
be below +5°C.
A maximum of four packages of the same type may be
stacked. Do not set heavy packages of another type on
top of the package.
The manufacturer cannot be held responsible for any
damage/injuries to objects or persons caused by
incorrect installation or use.
Rev. 00
7
7
Werbung
Inhaltsverzeichnis
