hanseatic HHI63BAF-CZ Gebrauchsanleitung Seite 54

Page EN-20 Using and caring for the hob
6 3
6
The timer indicator (10) will flash and show
the set time.
After 5 seconds, the timer indicator will be
constantly illuminated and will count the set
time down.
The flashing red dot next to the cooking
zone indicator shows that the cooking time
limit is activated for this cooking zone.
− −
Once the pre-set time has elapsed, the
cooking zone will switch off automatically
and the residual heat indicator "
up.
6
5. To switch off the cooking time limit in the
interim, touch the cooking zone sensor of
the active cooking zone.
The indicator for that cooking zone will
flash.
6. Touch the timer sensor
both setting sensors
The timer indicator will show "
" will light
H
0 0
and then touch
and .
".
00
Each touch of the setting sensors
/ reduces or increases the time by
1 minute. Touching and holding the setting
sensors / reduces or increases the time
by 10 minutes.
If you would like to amend the set time
in the interim, you will need to carry
out all of the steps once again.
Cooking time limits for several
cooking zones
You can set a cooking time limit for all 3 cook-
ing zones. The individual cooking times can
be of different lengths.
The timer indicator (10) always shows the
lowest time set for a cooking zone.
Example: For cooking zone 1, a time of 15 min-
utes is set; for cooking zone 2, a time of 10 min-
utes is set.
Requirement: The hob is switched on.
1. Set the time for cooking zone 1 to 15 min-
utes (see "Cooking time limit for one
cooking zone" on page EN-19).
2. Then touch the cooking zone sensor (8)
for cooking zone 2.
3. Set the desired heat level.
4. Use the same process to set the time for
cooking zone 2 to 10 minutes.
0
The timer indicator will show the time you
have set for cooking zone 2.
5
Cooking zone 1:
15 minutes
6 3
6
Cooking zone 2:
10 minutes