Product Description; Scope Of Delivery - Renfert ORTHO guide Set MT premium Anleitung

2.6 Disclaimer
Renfert GmbH shall be absolved from all claims for damages or warranty if:
en
► The product is employed for any purposes other than those specified in the operating instruc-
tions.
► The product is altered in any way other than those alterations described in the operating instruc-
tions.
► The product is not repaired by an authorized dealer or if original Renfert spare parts are not used.
► The product continues to be used despite obvious safety defects or damage.
► The product is subjected to mechanical impact or is dropped.
3

Product description

3.1 General description
You can extend the MT premium model trimmer using the MT premium ORTHO guide set.
The orthodontic model table and template enable precise trimming of the models.
The model can be precisely aligned using the guide light.
3.2 Assemblies and functional elements
See Fig. 1 (on inside cover)
1 Orthodontic model table
2 Template
3
Guide light
4 Sensor button
5 Connection cable
6
Clamping screw
7 Adjustment ring
3.3

Scope of delivery

1 Orthodontic model table
1 Template
1 Guide light
1 STEP-BY-STEP instructions
1 Assembly instructions
Demonstration models, 1 x upper jaw, 1 x lower jaw
4 Startup
4.1 Assembly – orthodontic model table
⇒ Pull the attached model table upwards from the ball head at the front edge and remove it.
⇒ Turn the adjustment fork to the 90° position with the long side facing upwards (see also the operating
instructions of the trimmer).
⇒ Insert the orthodontic model table and press it onto the ball head again.
⇒ Attach the template.
4.2 Assembly – guide light
⇒ Disconnect the power plug.
To mount the guide light you will need the trimmer Allen key.
This is located on the left side of the unit behind the door.
⇒ Open the door locks.
⇒ Remove the trimmer door and place it to one side.
⇒ Remove the Allen key from the holder.
- 2 -