Cleaning / Maintenance; Technical Data - Renfert ORTHO guide Set MT premium Anleitung

6

Cleaning / Maintenance

en
6.1 Orthodontic model table and template
The orthodontic model table can be cleaned in the same way as the standard trimmer model table.
⇒ Remove the template.
⇒ Pull the model table upwards from the ball head at the front edge.
⇒ Clean the model table and the template using a brush as appropriate under running water.
Do not use any objects with sharp edges or solvent-based / abrasive cleaning agents.
6.2 Guide light
Only wipe the housing of the guide light with a damp cloth.
Do not use any objects with sharp edges or solvent-based / abrasive cleaning agents.
7 Troubleshooting
Errors
The guide light cannot
be switched on.
The guide light does not
light up although the
trimmer is running.
8

Technical data

Supply voltage / VDC:
Current consumption / mA:
Laser:
- Laser class:
- Wavelength / nm:
- Output power P0, max. / mW:
Dimensions (width x height x depth) / mm [inch]:
Weight / g [oz]:
Cause
• The power plug of the trimmer is
not connected.
• The guide light is switched on/off
separately, independently of the
trimmer motor.
Corrective action
• Connect the power plug.
• Switch on the guide light at the sensor button (4, Fig. 1).
25 x 42 x 115 [0.98 x 1.65 x 4.53]
- 4 -
Guide light
5
30
1
650
5
40 [1.41]
Subject to change