Unit Description; Initial Use; Setting Up The Control Panel - Sanitas SBG 43 Gebrauchsanleitung

repairs
IMPOrtAnt
• Never open or attempt to repair the unit yourself, as otherwise proper function is no longer
guaranteed. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. unit description

Overview
1. Control panel with display
2. SET/ON button
3. Down key
4. Up key
5. Receiver
6. Scale
7. Transmitter
8. LED
9. Wall mount

5. Initial use

Inserting batteries
If present, pull the battery insulating strip off the battery compartment cover or remove the battery's pro-
tective film and insert the battery in the scale and the control panel with the correct polarity. Note the gra-
phic in the battery compartment.
control unit
2 x CR2032 3 V lithium batteries
Scale
4 x 1.5 V AAA batteries
If the scale fails to operate, remove the batteries completely and reinsert
them.
For instructions on changing the batteries, see p. 23.
changing the weight unit
On delivery the scale is set to the unit „kg". A switch located on the back of the control panel enables you
to change to „pounds" (lb).
Setting up the scale
Set up the scale on a level and solid surface. A solid surface is a prerequisite for a correct measurement.

6. Setting up the control panel

Positioning the control panel
The control panel can be held in the hand, attached to the wall mount or be left on the scale.
6
7
17
8
9
3
4
5
4 x 1,5 V Typ AAA
1
2