Setting Up; Safety Information; Check Contents Of Pack; Connecting The Base Station - AUDIOLINE DECT 4100 Bedienungsanleitung

3

Setting up

3.1

Safety Information

WARNING! Before setting-up, it is essential that you read the General
Information at the beginning of this manual.
3.2

Check contents of pack

The following items are supplied:
one base station
one handset
one telephone connecting cable
3.3

Connecting the base station

Position the base station near to your telephone connection socket and to
a mains socket. Your telephone works using Touch-Tone Dialling.
1. Insert the plug of the power supply into the socket on the rear of the
base station and plug the power supply into a properly installed 230 V
mains socket. The plug-in power supply for the base station must
always be connected. For safety reasons, use only the plug-in mains
power supply provided.
2. Connect the telephone cable supplied to the telephone socket and the
telephone jack on the rear of the base station. Use only the new
telephone cable provided.
3. If required, clamp the two cables in the cable channel underneath the
foot support and then run these through the two openings towards the
rear.
Note: The two plugs must audibly click into place so that they do not fall
out again.
32
- Setting up -
one mains power supply
two standard batteries
one instruction manual