Operating The Appliance; Switching On; Power Mode - CASO DESIGN Touch 3500 Original Bedienungsanleitung

Warning
► Do not move the appliance during operation or with hot cookware on the hot plate.
► Ensure that the cookware is properly centred on the hob. It must not be positioned on
the control panel or on the frame.
► In order to prevent overheating do not place any metal foil or metal panels on the
appliance surface.
► Do not touch the hot surface of the ceramic hob.
Although the induction cooktop itself does not produce any heat during the cooking
process, the temperature of the cookware does heat up the hob.
► Keep the hob and the underside of the pot clean and dry at all times. If liquid gets
between the base of the pot and the hob, this liquid can vaporise and the resulting
pressure can cause the pot to jump into the air, with a resulting risk of injury.
► Switch the appliance off after use. This avoids unnecessary use of energy, and ensures
your safety.
► If the appliance is unused for extended periods of time, we recommend that the
appliance be unplugged from the mains.

15.4 Operating the Appliance

15.4.1

Switching On

1. Plug the power plug into a suitable outlet.
2. The device emits a signal sound briefly, and the device then switches to standby
mode.
3. Left hob: Is the temperature of the surface of the induction cooker lower than 50°C, the
display shows „L". When the temperature of the cooker plate surface is over 50 °C, it is
displaying „H".
4. Now press the
On/Standby lights up.
15.4.2

Power Mode

Press the Select button. The signal lamps On/Standby and Power light up. The
preset power stage "1200" is selected and the device turns on. With the
buttons you can change the settings in a range from 500 – 2000 W (1500 W).
► We recommend to select the function "Power Mode" with 500-2000 W (1500 W) in
case of cooking similar to conventional stove.
► Left hob: maximum 2000 W. Right hob: maximum 1500 W.
Please note
On/Standby switch to turn on the device. The signal lamp
Please note
43