Pioneer BDR-X13EBK Gebrauchsanweisung Seite 16

Connection
Note
• It is recommended to connect to USB 3.0 port or above, since when a USB 3.0
cable is connected to a USB 2.0 port, the connection will be limited to USB 2.0
performance standards.
• This unit can operate with USB 1.1 but will not provide optimum performance.
• Connecting this unit through a USB HUB or using unspecified cables may not
guarantee proper operation.
• The unit will not run on power supplied from the USB connector (bus power). Be
sure to use the unit with the AC adapter supplied with the unit connected.
Caution
This product satisfies EMC regulations when shielded cables (with Ferrite-cores
attached) and connectors are used to connect the unit to other equipment. To
prevent electromagnetic interference with electric appliances such as radios and
televisions, use shielded cables (with Ferrite-cores attached) and connectors for
connections.
Forcefully ejecting the disc
In the following situation, you can forcefully
eject the disc by using the forced ejection
hole.
• When the device has malfunctioned and
the disc cannot be ejected using the eject
button or through the software
1 Check that the computer power is
turned off, and that the disc has
stopped rotating.
2 Straighten a paper clip or similar
object, and insert this straight
into the forced ejection hole and
push hard.
3 The disc tray will come out by
5 mm to 10 mm, so pull out the
tray and remove the disc.
16
BDR-X13EBK
Note
• Never forcefully eject the tray while
the disc is still rotating, as doing so
may lead to injury or damage to the
disc.
• Do not place items within 12 cm of
the front of the device, as doing so
may obstruct disc ejection.