Husqvarna PG 540 Bedienungsanweisung Seite 17

CAUTION:
high-pressure washer directly at
seals or connection points.
To do a general inspection
• Make sure that the power cord and extension cable
are in good condition and not damaged.
• Make sure that nuts and screws are tight.
• Make sure that the head locks are tight. If it
is necessary, tighten the head locks and use
®
LOCTITE 680 threadlocker.
Drive system for grinding head
The drive system for the grinding head is a closed
system. If you have problems with the drive system
of the grinding head, speak to your Husqvarna service
agent.
To install and remove the grinding head
WARNING:
when the grinding head is removed. Make
sure that the chassis can not fall. It can
cause injury or damage.
1. Push the chassis near the grinding head.
2. Put the motor cable from the chassis through the slot
between the grinding head and the chassis.
1211 - 004 - 09.12.2022
Do not point the
The chassis is not balance
3. Push the chassis fully against the grinding head (A).
B
A
4. Install the lock bolts (B) on each side of the grinding
head.
5. Attach the locking pins (C) on each side of the
grinding head.
6. Connect the motor cable from the chassis with the
motor cable from the motor (D).
7. Tighten the locknut (E) on the motor cable from the
chassis clockwise.
8. Put the motor cables into the cable holder (F).
9. Remove the grinding head in opposite sequence.
C
D E
F
17