Husqvarna PG 540 Bedienungsanweisung Seite 15

• Position 2: Minimum pressure on the grinding head.
This position is also used when you tilt the product to
servicing position.
To assemble and disassemble the weights
The product has 1 weight on each side of the product.
Do the procedure that follows on each weight.
1. Install the weight holder and tighten the 3 screws.
2. Put the weight on the cylinder on the weight holder.
1211 - 004 - 09.12.2022
3. Lock the weight to the weight holder with the locking
pin (A).
A
4. Fold the ring (B) on the locking pin on to the cylinder.
To adjust the weights
WARNING:
the weights. The moving parts can cause
injury.
WARNING:
weight lock locks correctly when the weights
are put in the selected position.
• Move the weight to a selected position with the
weight handle. Refer to
Be careful when you adjust
Always make sure that the
Weights on page 14 .
B
15