Husqvarna PG 540 Bedienungsanweisung Seite 12

• Servicing position of the handle:
To adjust the handle and the handlebar
WARNING:
the handle and the handlebar. Make sure
that the handle and the handlebar locks into
position. The moving parts can cause injury.
Set the handle height as close as possible to the height
of the operators hip. During operation the product can
pull to the side. The hip of the operator can help to stop
this movement to the side.
1. Pull the lock lever (A) on the handle in the direction
of the control panel and hold it in this position.
B
2. Adjust the handle (B) to an applicable operation
height.
3. Release the lock lever on the handle to lock the
handle position.
12
Be careful when you adjust
A
4. Loosen the lock knobs (D).
D
E
5. Adjust the handlebar (E) to the correct position.
6. Tighten the lock knobs to set the handlebar position
(F). When the handlebar position is set, pull the
handle lock knobs out and put them into idle
position.
To connect the product to a power
source
1. Connect the power plug of the product to the
extension cable.
2. Connect the extension cable to a mains outlet.
F
1211 - 004 - 09.12.2022