Husqvarna PG 540 Bedienungsanweisung Seite 10

tools. The dust below the grinding head is
dangerous to your health.
WARNING:
when you replace the diamond tools. The
dust extractor will decrease the dust that can
cause health problems.
CAUTION:
always have the same number and type of
diamonds. The height of the diamonds must
be the same on all grinding discs.
1. Turn the ON/OFF switch (A) on the control panel to
0. The LED adjacent to the ON/OFF switch goes off.
2. Push the emergency stop button (B) on the control
panel.
3. Set the handle in servicing position. Refer to
positions on page 11 .
4. If weights are installed, adjust the weights to a
rearward position. Refer to
page 15 .
5. Hold the handlebar and tilt the product rearward. Tilt
the product until the handlebar is on the floor.
WARNING:
product is in a stable position before you
replace the diamond tools.
6. Put on protective gloves.
10
Use the dust extractor
All the grinding discs must
B
A
Handle
To adjust the weights on
Make sure that the
7. Turn the tool plate (C) to the right or to the left to
unlock the tool plate from the grinding disc.
8. Pull the tool plate straight out (D) to remove the tool
plate from the grinding disc.
9. Use a hammer to remove the diamond tools from the
tool plate.
10. Attach new diamond tools to the tool plate with a soft
hit of the hammer.
C
D
1211 - 004 - 09.12.2022