Concept SM 3390 Bedienungsanleitung Seite 41

OPERATING INSTRUCTIONS
CAUTION
Prior to using a new unit, wipe the surface with a wet cloth and wash the removable accessories in warm
water due to hygienic reasons.
The unit has a built-in safety catch. The motor can be switched on only if the accessories are properly
mounted. Do not bypass the safety mechanism!
• Never leave the appliance unattended while it is running or connected to the mains.
• Some parts may keep moving for a while immediately after the motor has been switched off and the
power cord disconnected from the socket. Wait until the accessories stop completely and only then
open the lid.
MIXING
BLENDER IS DESIGNED FOR PROCESSING FRUIT AND VEGETABLE
1. Put the ingredients into the mixing jar (2) and screw in the blade assembly (4) to close the jar.
2. Put the mixing jar (2) onto the blender unit (1), so that the pins on the mixing jar (2) slip into the holes on
the blender body (1) and turn the mixing jar (2) clockwise until an audible click is heard.
3. Uncoil the entire cord and plug into the outlet.
4. Press and hold the PULSE button to start blending. Release the PULSE button to stop blending.
5. When you finish blending, unplug the cord from the outlet.
6. Separate the mixing jar (2) from the body of the appliance (1).
7. Unscrew the blade assembly (4) and replace it with the jar cover (3). If you open the cap, you can drink
directly from the jar.
CHOPPING
The chopping bowl is suitable for chopping meat, cheese, onions, herbs, garlic, carrots, walnuts, almonds,
dried plums, etc.
Do not attempt to chop extremely hard foodstuff s such as nutmeg, coff ee beans, or cereals.
Items like meat, cheese, onions, garlic, carrots, or frozen food must be cut before chopping.
Remove the stems from herbs and all nutshells.
Remove bones, cartilage and tendons from the meat.
1. Fill the chopping bowl (7) with the ingredients and close it with the
cover that holds the transmission.
2. Mount the unit body (1) on the lid with the transmission.
3. Uncoil the whole length of the power cord. Make sure it does not touch
any nearby sources of heat. Insert the plug into the electric voltage
socket.
4. Hold the body (1) with one hand and the chopping container (7)
with the other.
5. Press and hold the PULSE button to start chopping. Release the PULSE
button to stop chopping.
6. Switch the unit off after chopping. Use the release buttons to
disconnect the unit body (1) from the lid with the transmission. Disconnect
the cable from the socket.
7. Wipe the lid with the transmission using a wet cloth. Do not immerse in water or wash in running water!
SM 3390
EN
41