Maintenance - Hydro-Pro HYDRO PRO5 Bedienungsanleitung

12 rubber ring
13 Base tray
14 Gauge
15 Waterproof connection
16 Water connection
17 rubber ring
18 Heat exchanger
19 Water flow switch
20 Outlet water temp. sensor clip
21 Outlet water temp. sensor
22 Inlet water temp. sensor clip
23 Inlet water temp. sensor
24 Segregator
25 Left panel
26 Front panel
27 Piping temp. sensor
28 Service panel 2
29 Service panel 1
30 Electric box support panel

10. Maintenance

(1) You should check the water supply system regularly to avoid the air entering the system
and occurrence of low water flow, because it would reduce the performance and reliability of
HP unit.
(2) Clean your pools and filtration system regularly to avoid the damage of the unit as a result
of the dirty of clogged filter.
(3) You should discharge the water from bottom of water pump if HP unit will stop running for
a long time (specially during the winter season).
(4) In another way, you should check the unit is water fully before the unit start to run again.
(5) After the unit is conditioned for the winter season, he is preconize to cover the heat pump
with special winter heat pump.
(6) When the unit is running, there is all the time a little water discharge under the unit.
42 Terminal
43 Temp. controller fixture
44 Temp. controller
45 Clip
46 Terminal
47 Wire cover
48 Electric box cover
49 AC contactor
50 Water pump terminal
51 Phase protection board
52 Distributor assembly
53 Capillary assembly
54 Low pressure switch
55 4-way valve to segregator
56 4-way valve to heat exchanger
57 4-way valve
58 Return pipe
59 Ambient temp. sensor
60 Ambient temp. sensor clip
- 36 -