Hydro-Pro HYDRO PRO5 Bedienungsanleitung Seite 28

On standby or running mode, press
hour/minute.
Then press the
When setting the time,
6.5 Water temperature setting:
On standby or running mode, press
Note : the heat pump can running only if the water circle/filtration system is running.
6.6 Automatic start/stop the heat pump
To set the time to start the unit
Press to set the time to start the unit, then press
the time for start
5 minutes after the water pump).
Press again to store the new data.
To set the time to stop the unit
Press to set the time to stop running, then press
the time for stop
5 minutes before the water pump).
Press again to store the new data.
6.7 Concell the automatic start/stop
To concell the automatic starter
Press , then press
To concell the automatic starter
Press , then press
Note : If the water filtration system is stop before the heat pump, the unit will shut down
(security condition) and the code EE3 or ON advertise on the controller.
It is important to program the heat pump link the time program of the water filtration
system.
For restart the heat pump, turn off and turn on the electrical power supply to restart the
unit.
again to store the new data.
and cannot work.
and
, light off and the automatic start is off.
, light off and the automatic stop is off.
, then press
to adjust the desired water temperature
or
or
- 26 -
or to adjust
to adjust the time (set
to adjust the time (set