Jung FRWM200 Betriebsanleitung Seite 58

Press firmly magnetic carrier for about
10 seconds at the mounting position.
(3) Taking the device into operation and
setting up.
f Observe chapter 6 „Putting into
operation and setup" on page 60.
(4) Put the device on the magnetic
carrier.
5 The device is mounted on the
magnetic carrier.
The ultimate strength of the adhe-
sive bond is achieved after about
72 hours.
Adhesive mounting according
to EN 14604:2005/AC:2008
and vfdb 14/01 (Q)
To establish a permanent connection be-
tween the device and magnetic carrier
(e.g., as theft protection), you can addition-
ally mount the device with the supplied
adhesive film on the magnetic carrier.
58
Operating Manual: FRWM200 - Smoke Alarm Device with Radio Link
CAUTION
Possible property damage!
The mounting of the device according
to vfdb 14/01 (Q) establishes a
permanent connection between the
mounting surface and the device. Thus,
a subsequent removal of the device
is prevented. The start-up and set up
of the device are no longer possible.
If the device is disassembled, it can
cause damage to the device and the
mounting surface.
f Use the additional adhesive film
only to prevent theft.
f Put the device in operation and
set it up before attaching the
additional adhesive film.
When performing this type of installation,
proceed as follows:
(1) Mount magnetic carrier.
f Observe chapter „Adhesive mounting
according to EN 14604:2005/AC:2008"
on page 57.
EN