Rommelsbacher EKS 2010 Bedienungsanleitung Seite 37

• Attention: Make sure that the holes in the nozzle are always clean and not clogged.
• Attention: For moving the nozzle, only touch it at the upper plastic part.
• Attention: After frothing, the system must be cooled manually (see steps 12 – 15).
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
Step 4:
Choose the function "steam".
Step 8:
Remove the vessel.
• Check the water tank
regularly, refill water if
necessary.
• Check the drip pan
regularly, empty it if
necessary.
Step 1:
Prepare the appliance.
Step 5:
Switch the appliance on.
The appliance heats up and the pilot
lamp blinks. When the lamp glows
permanently, the appliance is ready
for use.
Step 9:
For frothing milk, dip the nozzle in
the pot with milk.
Step 2:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 6:
Start steam supply.
Turn the rotary knob to the right.
Produce steam for 2 - 3 seconds
to remove residual water from the
system.
Step 10:
Start steam supply.
Turn the rotary knob to the right.
Step 3:
Place a vessel below the outlet of
the hot water/steam nozzle.
Step 7:
Stop steam supply.
Turn the rotary knob to the left.
Step 11:
Stop steam supply.
Turn the rotary knob to the left.
37