Klarstein 10033600 Bedienungsanleitung Seite 98

EN
98
Installing the unit in the following locations may result in malfunction of the unit. The
following locations are not suitable for installation. If installation in any of these locations
cannot be avoided, contact customer service before installation:
• Locations with strong sources of heat, vapors, flammable or explosive gases, or
volatile objects dispersed in the air.
• Places where high frequency equipment is used (such as welding machines,
medical equipment, etc.).
• Places near the coast.
• Places where there are oils or vapours in the air.
• Places where sulphurous gases escape or are present.
• Places with similar conditions to those mentioned above.
• The unit must not be installed in washrooms.
• The unit must not be installed on unstable or moving structures (such as a truck) or in
corrosive environments (such as a chemical plant).
Step 1: Installation of the support of the Outdoor Unit
1 Select installation location according to the house structure.
2 Fix the support of outdoor unit on the selected location with expansion screws.
• Make sure that the wearer of the
unit can carry at least 4 times the
actual weight of the outdoor air
conditioner.
• The unit should be installed at least 3
cm above the floor so that the drain
can be installed.
• For units with a cooling capacity of
2300 W - 5000 W, 6 expansion
screws are required.
• For units with a cooling capacity of
6000 W - 8000 W, 8 expansion
screws are required.
• For units with a cooling capacity
of 10000 W - 16000 W, 10
expansion screws are required.
At least 3cm above the floor