Klarstein 10033600 Bedienungsanleitung Seite 112

EN
112
Replacing the Remote Control Batteries
On the back of the remote control, as shown in
the illustration, press down on the location where
the „OPEN" mark is located, then slide down the
battery compartment cover in the direction of the
arrow. Replace the two batteries (AAA 1.5 V) with
two batteries of the same type and make sure the
polarity is correct. Replace the battery compartment
cover.
• When using the remote control, the signal transmitter of the remote control should
be aimed at the reception window of the indoor air conditioner.
• The distance between the signal transmitter and the reception window should not
exceed 8 m and there should be no obstacles in between.
• The signal may be easily affected in rooms with fluorescent lamps or cordless
phones. The remote control should be close to the air conditioner when in use.
• Replace batteries with batteries of the same type when changing batteries becomes
necessary.
• Remove the batteries from the battery compartment if you will not be using the
remote control for an extended period of time,
• If the remote control screen is out of focus or shows nothing, replace the batteries.
Maintenance
• Check that the maintenance area or room in which the air conditioner is serviced
meets the requirements on the nameplate. Maintenance may only be carried out in
areas that meet these requirements.
• Ensure that there is adequate ventilation of the maintenance area during all
maintenance work.
• Ensure that there are no fire sources or potential fire sources in the service area.
Open flames are prohibited throughout the service area. It is recommended that
you hang a „No Smoking" sign.
• Check that the appliance label is in good condition. Replace hard-to-read or
damaged equipment labels.