Klarstein 10033600 Bedienungsanleitung Seite 75

• The two functions Timer on and Timer off can be activated simultaneously.
• Set the current time on the unit before activating the timer.
• Set valid values after activating the respective timer function. The POWER button
does not affect the setting. If you do not need this function, deactivate it with the
remote control.
CLOCK - Setting the Time
• Press the CLOCK button to set the time. The clock icon
control.
• Within 5 seconds, press the ARROW KEYS to adjust the time. Pressing the respective
button will either add one minute to the time or subtract one minute.
• If you press and hold the ARROW KEYS, the number of minutes changes faster.
Release the button once the desired time has been set.
• Press the CLOCK button to confirm your setting. The clock symbol will stop flashing.
Note: The time is displayed in 24-hour format. The time between two entries must not
exceed 5 seconds, otherwise the setting mode will be cancelled. See point 10 for
activating the timer.
QUIET - Quiet Mode
When the QUIET button is pressed, the auto silent mode is activated (the icons
AUTO are displayed on the screen), when the button is pressed again, the normal silent
mode is activated (only the headphone icon is displayed on the screen), and when the
button is pressed three times, the silent mode is deactivated (the headphone icon is not
displayed on the screen). When turned on, the silent mode is the default setting.
• The silent mode can be set in all modes. Fan speed adjustment is not possible in this
mode.
• If the silent mode is selected, this has the following effect on the different modes:
• The indoor air conditioner runs at speed level 4. Ten minutes later, or when the
indoor temperature is ≤ 28 °C, the unit continues to run either at speed level 2 or in
silent mode, depending on the difference between the ambient temperature and the
set temperature.
• In heating mode, the air conditioner continues to run at either speed 3 or quiet
mode, depending on the difference between the ambient temperature and the set
temperature.
blinks on the remote
and
EN
75