Master/Slave Operation; Operation; Stand-Alone Mode; Control Board - EuroLite LED Mini Strobe Bar Bedienungsanleitung

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the desired Master-mode - „Sou1 or AFXX" - for the master-device and set the DMX address 001 for all
slave-devices.
Please refer to further instructions under Control Board.

OPERATION

After you connected the LED Mini Strobe Bar SMD 48 to the mains, it starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, UP, DOWN and
ENTER.
The device has two operating modes. It can be operated in Stand Alone via LED display with operating
buttons or in DMX-controlled mode via lighting controller.

Stand-alone Mode

In the Stand Alone mode, the device can be used without a controller. Disconnect the device from the
controller.

Control board

The control board offers several features, i.e. setting the DMX starting address or
running a pre-set program.
Browse through the menu by pressing MODE. You can change the selection by
pressing UP or DOWN. Press ENTER in order to confirm. You can leave every mode by
pressing MODE. The functions provided are listed in the following sections.
MODE UP DOWN ENTER
Display
Axxx
disp
LodR
VEr
Afxx
Sou1
Setting
DMX address setting
A001 - A512 With this function, you can adjust the desired DMX-address
via the Control Board.
Display reverse 180 degrees
Yes With this function you can flip the display by 180° for a better
view when the fixture is hung from the truss or a ceiling.
Restore factory settings
Yes
With this function you can restore the factory settings.
View software version
Strobe effect
Af00 - Af16
With this function you can select the strobe program in 17
different speeds (increasing).
Music controlled program
A flash is triggered with every bass-beat.
Function
18/20 00099112, Version 1.0