Dmx Mode; Dmx-Protocol - EuroLite LED Mini Strobe Bar Bedienungsanleitung

DMX Mode

You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button until the display shows Axxx. You can now set the desired address (001 - 510) via
the UP or DOWN buttons.
Controlling:
After having addressed the LED Mini Strobe Bar SMD 48, you may now start operating it via your lighting
controller.
Please, be sure that you don't have any overlapping channels in order to control each fixture correctly and
independently from any other fixture on the DMX-chain. If several fixtures are addressed similarly, they will
work synchronically.
Please see the following DMX protocol graphic for the respective channel values.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
data received at the DMX-input, a dot on the LED display will blink. If there is no data received, the dot will
not blink.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective
- the cable or connector is defective or the signal wires are swap in the input connector.

DMX-Protocol

Channel
1 000-255
Channel
2
000-255
Channel
000-036
037-072
073-107
3
Strobe 108-144
Effects
145-180
181-253
254-255
Value Characteristic
Gradual adjustment of the dimmer intensity from 0 to 100 %
Value Characteristic
Gradual adjustment of the strobe speed from 0 to 100 %
Value Characteristic
Strobe
Pulsing
Fast open, slow close
Slow open, fast close
Random strobe
Slow pulsing from 6 to 14 seconds
Sound control
19/20 00099112, Version 1.0