Interrupting Operation; Finish Operation - Kärcher K 5 Bedienungsanleitung

facturer must be adhered to, especially the
instructions regarding personal protective
equipment.
Notice
Risk of damage to the appliance
 Apply the "Ultra Foam Cleaner TM 615"
cleaner via the foam nozzle only.
Notes regarding the detergent: The most
commonly used KÄRCHER detergents can
be purchased ready to use in their Plug 'n'
Clean detergent bottles with locking lids.
This will make the pesky refilling and filling
processes redundant.
Illustration
 Remove the lid from the Plug 'n' Clean
detergent bottle and press the deter-
gent bottle into the detergent connec-
tion with the opening facing down.
Illustration
 Adjust the suction volume of the deter-
gent solution by means of the dosage
regulator for detergents.
 Use spray lance with pressure regula-
tion (Vario Power).
 Turn the spray lance to "Mix" position.
Note: This will mix the detergent with
the water stream.
 Fill the detergent solution in the deter-
gent tank of the foam nozzle (observe
dosage instructions on the packaging of
the detergent).
Recommended cleaning method
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high
pressure jet.
Optional
Foam nozzle
 Fill the detergent solution in the deter-
gent tank of the foam nozzle (observe
dosage instructions on the packaging of
the detergent).
 Connect the detergent tank to the foam
nozzle.
 Connect the foam nozzle to the trigger
gun.
Suck 'n' Clean
 Release the lever on the trigger gun.
 Lock the lever on the trigger gun.
 Insert the trigger gun in its holder.
 During longer breaks (more than 5 min-
utes), also turn the appliance off using
the "0/OFF" switch.
Caution
Only separate the high-pressure hose from
the hand spray gun or the appliance when
there is no pressure in the system.
 Remove the Plug 'n' Clean detergent
bottle from the intake and close it with
the lid. To store, place into the intake ro-
tated by 180°.
 Release the lever on the trigger gun.
 Turn off the appliance "0/OFF".
 Turn off tap.
 Press the lever on the trigger gun to re-
lease any remaining pressure in the
system.
 Lock the lever on the trigger gun.
 Disconnect the mains plug from the
socket.
 Detach the appliance from the water
supply.
– 11
EN

Interrupting operation

Finish operation

21