EINHELL HR 1700 F Bedienungsanleitung Seite 10

Anl. HR 1700 F 12-spr.
GB
* These components cannot be supplied.
1 Water supply
1a Non-return valve with pipe vent
2 Intermediate container
3 High-pressure water pump
5 Pressure valve
6 Detergent container
7 High-pressure hose
8 Pistol
9 Pistol lever
10 Lance
11 Nozzle head
12 Nozzle
How to use the machine correctly
The high-pressure cleaner has to be stood
horizontally on a flat, firm surface.
It is advisable to adopt the correct working position
whenever you actuate the machine: One hand
holding the pistol and the second hand holding the
lance.
Never direct the water jet at electric cables or at the
machine itself.
10
08.11.2001 13:24 Uhr
Round brush not supplied
(special accessory)
Seite 10
Fitting the lance
The lance has a shaped element (item 1) for latching
on the spray pistol (item 2). First turn the lance in the
direction of the arrow 'A' and then turn it clockwise
approx. 15° until the two components are fully
connected (cf. the figure below).
Dirt which may collect in the nozzle can be removed
with the nozzle cleaning needle (item 4). Caution! Be
sure to turn off the machine and disconnect the water
supply first.
Starting
After connecting the high-pressure cleaner to the
power supply and the water supply, proceed as
follows:
1. Open the water tap.
2. Press the pistol trigger to allow any air to escape.
3. Set the on/off switch to '-1-'.
Pistol safety device
It is imperative to actuate the safety catch (S) on the
pistol whenever you stop the machine. This will
prevent the machine starting accidentally.