ECG ERB 21420 WF Bedienungsanleitung Seite 7

The description and information of the appliance may vary according to the type of model. This
appliance is not intended for use as a built-in appliance.
DESCRIPTION
This description only applies to information regarding
the components for the appliance.
Individual parts may diff er according to the particular
appliance model.
A) Freezer
B) Refrigerator
1. Thermostat (on the right side)
2. Refrigerator shelves
3. Cover of storage space for fresh vegetables and
fruits
4. Drawer for storing fresh fruit and vegetables
5. Freezer drawer / Tilting cover
6. Door compartments
* diff ers according to the specifi c model of the
appliance – see information sheet
INSTALLING AND TURNING ON THE APPLIANCE
• You can contact the service technicians to install and turn on the device properly.
• Before connecting the electricity, make sure that the voltage stated on the label corresponds to the
voltage in the socket / voltage for the electricity system in the building.
• The outlet must be accessible after installing the appliance.
Installing the device
• Place the refrigerator away from any sources of heat and in a well-ventilated position.
The refrigerator should be located a minimum of 50 cm away from radiators, gas stoves
and other heat sources, and 5 cm away from electric stoves.
• Leave free space of minimum 15 cm above the appliance.
• Connect the plastic spacer to the condenser on the rear wall of the refrigerator to
prevent the refrigerator from leaning against the wall and thereby reduce its power.
• Do not place heavy items on the refrigerator.
• If the appliance is installed beside another refrigerator or freezer, keep a minimum
distance of 2 cm to prevent vapour condensation.
• The refrigerator must stand fi rmly in a horizontal position. Use the two adjustable front feet for levelling.
2
3
4
5
1
B
6
A
7