Removal Of Failure; Safety Precautions; Cause And Removal Of Failure - Hama KHL48 Bedienungsanleitung

Removal of failure

Removal of failure
This chapter contains important information on cleaning and care of
the unit. Please observe the notes to prevent dangers and damage.

Safety precautions

WARNING
Observe the following safety precautions to avoid any injuries and
damage:
► Repairs to electrical unit may only be carried out by specialists
trained by the manufacturer. Unqualified repairs can pose con-
siderable dangers for the user and serious damage to the unit.

Cause and removal of failure

The following table will help you locate and remedy smaller failures:
Fault
No LED flashes
on the control
2
after press-
ing button
Pouches are
not properly
laminated.
The inserted
pouch does not
come out the
rear side
KHL 48
Possible cause
On/off button has not
been pressed.
Mains cable not con-
nected correctly.
The mains socket
8
.
does not provide any
voltage.
Unit is defective.
The temperature has
not been set to the
film thickness being
used.
The item to be
laminated is possibly
stuck or is too large
to pass through the
rollers.
Remedy
Press the on/off button to
switch on the device
Make sure that mains
plug has been connected
to the mains socket.
Check the fuses.
Contact after-sales
service.
Set the thickness to be
used in the device by
pressing the button
4
Press the lever down-
wards to dispense the
item from the front side.
Check that the item is
not above the maximum
allowed thickness.
g
7
.
35