Eibenstock EHB 16 / 1.4 S R/L Originalbetriebsanleitung Seite 15

Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off: press the on/off switch and release it again
Attention!
Only press the lock-on button when using a stand. In case
!
of every stop of the machine, the lock-on button has to be
released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of the
machine (physical hazard).
The hand-held drilling machines EHB 16/1.4 S R/L is equipped with an
electronic switch allowing the slow start of drilling.
With this switch the speed can be regulated according to the pressure on
the button.
A permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be
overheated much faster.
Additional the machine has a change-over switch in the switch handle for
reverse action.
Use the change-over switch only when the spindle is stopped!
Care and Maintenance
Before starting with the maintenance- und repair works
you have to disconnect the plug from the mains.
Repairs have to be carried out only by qualified and due to education and
experience suited personnel.
After every repair the machine has to be inspected by an electric specialist.
Due to its design, the machine needs a minimum of care and maintenance.
The following works have to be carried out regularly:
The electric tool as well as the ventilation slots always has to be
clean.
During work, please pay attention that no foreign elements get into
the interior of the machine.
In case of failure, a repair has to be carried out by an authorized
service workshop.
Our after-sales service responds to your questions concerning
maintenance and repair of your product as well as spare parts.
EIBENSTOCK's application service team will gladly answer questions
concerning our products and their accessories.
15