Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
During use, the user must wear goggles, ear protectors and protective
gloves.
During use, hold the machine with both hands and maintain a
safe standing position. Always consider the reaction moment of
the tool.
Always work with concentration. Always work in a carefully
considered way and do not use the tool if you are lacking
consideration.
For further safety instructions, please refer to the enclosure!
Before starting the machine, please check the correspondence between
voltage and frequency against the data mentioned on the identification
plate. Voltage differences of + 6 % and – 10 % are allowed.
The hand-held drilling machine is made in protection class II.
Only use extension cables with a sufficient cross section. A cross section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Additional Handle
The hand-held drilling machine may be used only together with its
additional handle which comes with the tool.
Place it on the gearing collar from the front, bring into the requested
position and fix it tightly by counterclockwise rotation of the handle.
Tool Protection
Wrong handling can cause damages on the tool and injuries of the user.
Therefore, the following instructions should be observed:
Do not allow blocking of the tool.
Switching on and off
Short-Time Operation
Switching-on:
press the on/off switch
Switching-off:
release the on/off switch
Electrical Connection
14
Werbung
Inhaltsverzeichnis
