Room Ventilation Opening For Air Intake From The Setup Room - Miele PDR 516 SL EL Installationsplan

Room ventilation
opening for air in-
take from the
setup room
With complex ducting with many bends and additional compon-
ents, or when several different appliances are connected to a
shared duct, it is recommended that a detailed pipework calcula-
tion is carried out by a qualified specialist.
The vent ducting must not be channeled into a chimney or flue
already in use for any gas, coal or oil-burning installation. The warm
and moist exhaust air is to be conducted to the outside or through
suitable ventilation ducting along the shortest path possible. The vent
ducting must be laid so that air flow is not hindered. To achieve this,
use as few bends as possible along with short pipelines and well-
made connections and transitions checked for air-tightness. No filters
or grilles may be fitted in the vent ducting.
The end of the vent ducting leading outside must be protected
against the elements, e.g. with a downward-facing 90° elbow.
 During tumble dryer operation, the room must be adequately
ventilated.
The minimum dimension of the ventilation opening depends on the
cross-section of the extraction ducting.
If the tumble dryer is connected to a central air supply, additional
ventilation openings are normally not needed.
Extraction ducting
 
150 mm -
- 150 mm
180 mm -
- 180 mm
200 mm -
- 200 mm
220 mm -
- 220 mm
250 mm -
- 250 mm
300 mm -
- 300 mm
en - Installation notes
Minimum dimension for ventilation opening
A A
177 cm² 531 cm²
225 cm² 675 cm²
254 cm² 762 cm²
324 cm² 972 cm²
314 cm² 942 cm²
400 cm² 1200 cm²
380 cm² 1140 cm²
484 cm² 1452 cm²
491 cm² 1473 cm²
625 cm² 1875 cm²
707 cm² 2121 cm²
900 cm² 2700 cm²
 
260 mm 230 mm
295 mm 260 mm
315 mm 280 mm
355 mm 315 mm
350 mm 310 mm
395 mm 350 mm
381 mm 377 mm
430 mm 382 mm
435 mm 385 mm
490 mm 435 mm
520 mm 460 mm
590 mm 520 mm
25