Maintenance - eta emma Bedienungsanleitung

Temperature maintenance feature
When in stand-by mode, press and hold A1. Green signal lamp will start flashing on
display A6, over the "
preset temperature has been reached, sound signal will be given and the maintaining
temperature function will be activated automatically (signal lamp over the "
continuously). This function will remain active for approx. 2 hours, then the device will be
switched off automatically. This function can also be deactivated by pressing A1.
Memory (for Keep Warm function)
The electric kettle is equipped with memory function. It can be used if the kettle has been
switched on and the Keep Warm function active. If the kettle will be removed from its base
in the Keep Warm mode, and then put on it again, it will continue keeping the temperature.
Press A1 to switch off the kettle and disable the memory.
– If the kettle is not on the base plate, the electronic operation system is not active.
– If the heating temperature is lower than current water temperature in the kettle, the kettle
will be switched on and waiting until the temperature drops to the set value (sound signal
will be given).
– If you are preparing food for very young children (e.g. to 40 °C), the water must
be heated to a boil (100 °C) first.
– When heating water, the lid must be closed, otherwise the kettle will not turn OFF.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up to
maximum, water can flow out from the electric kettle in the bottom part of the kettle.
This does not affect safety or other functions and it does not mean any failure of the
electric kettle. In the case of tilting the electric kettle with hot water there is a risk of
scalding. Therefore do not tilt the electric kettle.
– During heating, current temperature will be displayed until the set temperature value is
reached. Then preset temperature will be displayed. The temperature sensor is located
at the bottom of the kettle, consequently, the temperature will be displayed with a small
tolerance, due to temperature difference in the bottom and upper part of the kettle.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord
out of the socket! Clean the kettle only when it is cooled down! Do not use rough
and aggressive detergents (e.g. sharp objects, scrapers, diluting agents or other
solvents)! The housing of the kettle is made of high-quality plastic, the heating bottom
and inner surface of the kettle are made of high-quality stainless steel, however, a slight
sediment (scale) during standard use /particularly, above the heating element/ cannot
be avoided. It is not rust or another material defect of the kettle container and the
appliance is not subject to a complaint for this reason.
Cleaning the kettle
Pour about 50 g citric acid to the kettle with the water scale sediment. Fill the kettle
to about one half and mix. After it dissolves, fill the kettle to 3/4 of the maximum amount
of water. Place the electric kettle on the stand and turn it on. Before boiling, turn off the
kettle, let the solution take effect for about 10 minutes and then pour it out. Clean the
kettle thoroughly with clean water. Repeat the whole procedure if the kettle is too soiled.
Clean the electric kettle regularly!
" sign. Then continue by setting the required temperature. After
Notes
17 / 34
EN
" sign will light