Programming - Fagor FEC-805T Bedienungsanleitung

EN 4 / PROGRAMMING YOUR MACHINE

• PROGRAMMING

Nature of the washing and
the temperature
1
Spin speed setting
(depending on the model)
• Programming a washing cycle:
1
— Turn the selector to choose the most suitable programme and washing temperature for
the type of fabric to be washed.
NB:
Turning the selector to any position other than "O" provides power to the machine.
2
— Using the selector (depending on the model), choose:
- Either a suitable spin speed for your type of washing.
The spin speed is automatically restricted in the "Synthetics", "Woollens / Delicates"
and "Hand wash" programmes.
- Or drip dry.
The cycle will finish with a gentle spin at 100 rpm.
- Or stop with tub full of water.
Your machine will stop with the tub full of water before the final spin.
3
— Use the buttons to select any options you wish.
— Start the programme by pressing "Start/Pause"
— ... Or use the selector 5 (depending on the model) to select starting delayed by 1 to 19
hours and then press "Start/Pause"
• Adding or removing an item during the cycle
— Press the "Start/Pause" button
— Add or remove the items of laundry
— Press the "Start/Pause" button
(*) The lid may take 1-2 minutes to unlock.
• Cancelling while programming, washing or during a pause:
1
— Set the selector to the "O" position.
This can be done at any time during the cycle or during programming, or even during a pause.
NB :
- In all cases, after cancelling you must reprogramme everything from the start.
- If you have cancelled during the washing phase, remember to empty the water, if necessary.
• End of the cycle:
NB:
After spinning, some models automatically position the drum opening at the top to
provide easy access to the washing. This operation lasts at most 3 minutes.
— Then, the "Stop" light comes on permanently, indicating that the cycle is over.
Set the selector 1 to the "O" position.
You can now open the lid and remove your washing.
For more details on the various functions, please refer to the sections "DETAILS OF THE PROGRAMMES" and "DETAILS OF THE OPTIONS".
Information :
After a power failure, when the power is restored, the washing cycle automatically resumes at the point where it was interrupted.
All manuals and user guides at all-guides.com
Cycle progress
A
5
2
Delayed
start setting (depending on the model)
4
4
.
(impossible during spin):
4
to interrupt the cycle.
* .
4
to restart the cycle.
Start/Pause
4
3
Options
(depending on the model)
Indicator lights and position of the selectors
(If you have selected rinse only or spin only,
it is the "Rinse/Spin" light
- Position "800" for example
- Position "100"
- Position
(The lights
The lights
6
Information:
All the buttons are on micro-
switches and do not remain depressed.
In any case, the"Start/Pause" button
cannot cancel a programme.
Important :
Before starting your machine,
check that the power cable is plugged
in and the water tap is open. Also
ensure that the drum doors are closed
correctly and the machine's lid is shut.
During the "End of Cycle" phase, any
action on one of the controls (the
selectors or the buttons) returns you to
"Programming" mode. As a safety
measure, when the cycle is over, we
recommend that you unplug the power
cable and turn off the water tap.
"Wash" light flashing
that flashes
2
Selector on
Light(s) for the option(s) selected
"Wash" light permanently lit
A
illuminate in succession to show
which phase the cycle is at)
A
flash in succession until the cycle
effectively starts
A
Light flashing
A
Light permanently lit
1
Selector set to "O"
All the lights unlit
The "Stop" light is permanently lit