INVENTOR V7CRI-18WiFiR/U7RS-18 Installationshandbuch Seite 14

Indoor Unit Installation
Installation Instructions – Indoor unit
Indoor Unit Installation Instructions
NOTE: Panel installation should be done
NOTE: Panel installation should be performedafter piping and wiring have been completed.
after piping and wiring.
Step 1: Select installation location
Step 1: Select installation location
Before installing the indoor unit, you must
The indoor unit should be installed in a location
choose an appropriate location. The following
that meets the following requirements: are standards that will help you choose an
appropriate location for the unit.
The unit is at least 1m (39") from the nearest
o
wall.
Proper installation locations meet the
There is enough room for installation and
o following standards:
maintenance.
Enough room exists for installation and

There is enough room for the connecting
o
maintenance.
pipe and drainpipe.
Enough room exists for the connecting the

The ceiling is horizontal and its structure can
o
pipe and drainpipe.
sustain the weight of the indoor unit.
The ceiling is horizontal and its structure can

The air inlet and outlet are not impeded.
o
sustain the weight of the indoor unit.
The airflow can fill the entire room.
o
The air inlet and outlet are not blocked.

There is no direct radiation from heaters.
o
The airflow can fill the entire room.

There is no direct radiation from heaters.

RECOMMENDED DISTANCES BETWEEN THE INDOOR UNIT AND THE CEILING
The distance between the mounted indoor unit and the internal ceiling should meet the following
Recommended distances between the indoor unit and the ceiling
specifications. (See Fig. 3.2)
The distance between the mounted indoor unit and the internal ceiling should meet the following
specifications.
(A)
Ceiling board
ƒPage 14
„
Ceiling
B (Ceiling hole)
>250cm / 98.4"
Ground
Fig. 3.2
CAUTION
DO NOT install the unit in the following
locations:
install unit in the following
DO NOT
In areas with oil drilling or fracking
locations:
In coastal areas with high salt content in
Areas with oil drilling or fracking
the air
Coastal areas with high salt content in the
In areas with caustic gases in the air, such
air
as near hot springs
Areas with caustic gases in the air, such as
In areas with power fluctuations, such as
hot springs
factories
In enclosed spaces, such as cabinets
Areas that experience power uctuations,
such as factories
In kitchens that use natural gas
Enclosed spaces, such as cabinets
In areas with strong electromagnetic waves
Kitchens that use natural gas
In areas that store flammable materials or gas
Areas with strong electromagnetic waves
In rooms with high humidity, such as
Areas that store flammable materials or gas
bathrooms or laundry rooms
Rooms with high humidity, such as
bathrooms or laundry rooms
Front panel
Page 21
 
 Page 11 