Behaviour In An Emergency Situation; Assembly; Please Observe The Enclosed Assembling Instructions; Start-Up - ATIKA LSH 2500 Originalbetriebsanleitung

The electrical connection or repairs to electrical
parts of the machine must be carried out by a certi-
fied electrician or one of our customer service
points. Local regulations
tective measures must be observed.
–
Repairs to other parts of the machine must be car-
ried out by the manufacturer or one of his customer
service points.
Use only original spare parts. Accidents can arise for
the user through the use of other spare parts. The
manufacturer is not liable for any damage or injury
resulting from such action.

Behaviour in an emergency situation

 Initiate all required first aid measures suited for the injury
and seek qualified medical advice as quickly as possible.
 Protect the injured person against further injuries and
immobilise the injured person.

Assembly

Please observe the enclosed assembling
instructions!
Connect the leaf sucker to the power supply system
only after having finished the complete assembly.
Assembling the suction tube
2 Slip the wheels with holder (13) up to the stop on the
front suction tube (11) and screw them on.
3 Then connect the front (11) on the rear suction tube
(10) and screw them together.
4
Then, insert the completed suction tube (10+11) in
the machine body (5) and screw both together.
Fixing the handle
5 Insert the front handle (6) in the dedicated opening of
the machine body (5) and engage it.
Fixing the collecting bag
6 At first, hook up the front end of the collecting bag
(12) on the rear suction tube (10).
7 Then, hook up the rear end of the collecting bag (12)
on the machine body (5).
8 Finally, slip the opening of the collecting bag (12) on
the dedicated opening on the machine body (5).
Fixing the carrying strap
9 Put the loop of the carrying strap (7) through the
provided opening on the machine body (5) and screw
it on.

Start-up

 Check that the machine is completely and correctly as-
sembled.
 Before using the shredder, make sure each time that
the supply / extension cable for damages (cracks, cuts
−
or the like) or ageing (brittleness).
especially regarding pro-
–
Do not use defective supply or extension ca-
bles.
there are no damage at the machine
−
all screws are tight
−
the collecting bag shows no signs of wearing or quality
−
deterioration

Mains connection


 Compare the voltage given on the machine model plate
with the mains voltage and connect the machine to the rel-
evant and properly earthed plug.
 Only use connection cables with sufficient diameters.
 Do not use any defective connection cables.
 Connect the machine via a 30 mA fault current safety
switch.
 Use connecting or extension cables up to a length of 1.5 m
featuring a core cross section of at least 25 mm²
Fuse protection: 10 A


Mounting of the extension cable

1. Plug the female connector of
the extension cable on the
male connector (14) of the de-
vice.
2. Thread the extension cable
through the pull relief device
(8) as a loop and hang it up.
3. Make sure that the extension
cable has enough free motion.

Switching on/off

The On/Off switch is integrated in the handle.
Hold the switch pressed to start the leaf sucker. The leaf
sucker stops automatically when you release the switch.
Do not use any device where the switch cannot be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
15