Installation; Mounting On The Floor; Fixing To A Truss - EuroLite UP-4 Entry Bedienungsanleitung

INSTALLATION

WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must
never be fixed swinging freely in the room.

Mounting on the floor

Folding foot adjustable in 5 steps:

Fixing to a truss

The device can be attached to your truss system using a suitable TPC coupler. Use a coupler with an M10
screw - check the mounting hole on the side of the device. (see graphic)
1 Insert the M10 screw into the mounting hole on the side of the truss light and then tighten it together with
the TPC coupler.
2 Hook the TPC coupler into the truss and tighten the locking screw.
3 Always secure the installation with a safety bond (see graphic and accessories). Before mounting, make
sure that the mounting surface can withstand at least 10 times the point load of the installation's own
weight.
The structure (truss) to which you are attaching the fixtures is secure.
Use an appropriate coupler to rig the fixture on the truss.
Make sure that the device is fixed properly! Ensure that
CAUTION!
25/36 00133326, Version 1.0