Cleaning The Grid; Storage - Electrolux RO 400 Handbuch

11 If there is any odour left from the cleaning agent, open
the tap and allow it to produce water until the odour
has disappeared.
12 Reassemble the equipment and reconnect the purified
water hose to another appliance or item of ancillary
equipment.
The disinfection procedure is now complete and the
RO 400 is ready for regular use.

Cleaning the grid

The grid (a coarse filter) filters out large particles and is
located in the connection for the feed water on the
appliance. If the "filter I" indicator light shows that filter
is blocked or that the intake pressure is too low, the reason
may be that the grid is clogged.
1 Disconnect the appliance from the electrical supply.
2 Close the valve on the water supply pipe.
3 Undo the feed water hose connector on the back of the
appliance.
4 Using pliers or similar, grip and remove the grid, as
shown in fig. G.
5 Clean and rinse out the grid before putting it back
inside the connector (with the tongue for the pliers
facing outwards), see fig. G.
6 Reconnect the feed water hose to the appliance.
7 Open the valve on the cold water supply pipe and check
that there are no leaks.
8 Plug the appliance back in at the mains and it will flush
automatically.

Storage

If the RO 400 is not going to be used for a period of more
than four months, or if it is going to be disconnected from
the water and electricity mains supplies for quite a long time
(several days) it needs to be filled with a preserving agent.
The preservative can be ordered from your dealer (see
"Service and spare parts").
This product must be kept out of the reach of
children.
Wash your hands after use!
1 Unplug the appliance from the mains.
2 Mix 2 litres of the preservative agent and 4 litres of
water in a bucket, see fig. H.
3 Undo both filter containers as described in "Replacing
the filters", steps 3-6. Remove the two filter inserts and
discard them (should not be kept for re-use). Empty the
water from the containers, see fig. I
4 Put the empty filter containers back in their normal places
and tighten them. Make sure that each sealing ring is in
place in the groove on the top edge of each container.
G
H
overleaf.
MAINTENANCE
65