Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Sliding mitre saw
A)
No-load speed
Laser type
Laser class
Divergence of laser line
Weight according to EPTA-Procedure
01:2014
Recommended ambient temperature
during charging
Permitted ambient temperature during
C)
operation
and during storage
Recommended rechargeable batteries
Recommended chargers
Dimensions of suitable saw blades
Saw blade diameter
Base blade thickness
Hole diameter
A)
Measured at 20−25 °C with rechargeable
battery ProCORE18V 8.0Ah.
B)
Depends on battery in use
C)
Limited performance at temperatures <0 °C
Permissible workpiece dimensions (see "Permissible workpiece dimensions", page 33)
Noise Information
Noise emission values determined according to
EN 62841-3-9.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 95 dB(A); sound power level
104 dB(A). Uncertainty K = 3 dB.
Wear hearing protection!
The noise emission value given in these instructions has
been measured in accordance with a standardised measur-
ing procedure and may be used to compare power tools. It
may also be used for a preliminary estimation of noise emis-
sions.
The noise emission value given represents the main applica-
tions of the power tool. However, if the power tool is used
for other applications, with different application tools or is
poorly maintained, the noise emission value may differ. This
may significantly increase noise emissions over the total
working period.
To estimate noise emissions accurately, the times when the
tool is switched off, or when it is running but not actually be-
ing used, should also be taken into account. This may signi-
ficantly reduce noise emissions over the total working
period.
Bosch Power Tools
-1
min
nm
mW
mrad (full angle)
kg
°C
°C
mm
mm
mm
Assembly
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
Items included
Check to ensure that all the parts listed below have been
supplied before using the power tool for the first time:
– Sliding mitre saw with mounted saw blade
– Dust bag (2)
– Transport handle (4), two screws for assembly
– SDS bolt (46)
– Screw clamp (26)
– Hex key (41)
Note: Check the power tool for possible damage.
Before continuing to use the power tool, carefully check that
GCM 18V-216
4600
650
< 0.39
1M
1.0
B)
15.1−16.1
0 to +35
–20 to +50
GBA 18V...
ProCORE18V...
GAL 18...
GAX 18...
GAL 36...
216
1.2−1.8
30
See the list of items included at the start of
the operating manual.
1 609 92A 6ST | (09.07.2021)
English | 29
GCM 18V-216
4600
650
< 0.39
1M
1.0
B)
15.1−16.1
0 to +35
–20 to +50
GBA 18V...
ProCORE18V...
GAL 18...
GAX 18...
GAL 36...
216
1.2−1.8
25.4
Werbung
