Philips AC 914 Bedienungsanleitung Seite 14

and you will receive the
message. When the message
has been read through
playback is continued.
— DK: (during fast winding)
Fast winding and fast
searching in the MSS mode will
also be interrupted as soon as
traffic information is broadcast,
provided your car radio is
tuned in to the correct
transmitter and the radio is in
the INFO mode. Then the unit
will switch over to radio
reception and you will receive
the traffic information.
— Atthe end of the end of the
message cassette playback is
continued, if you were listening
to a cassette when you started
fast winding.
— If you started fast winding
while you were listening to the
radio (cassette player in
stand-by mode) radio
reception is continued, also
after the traffic information has
been broadcast.
Note: The sound level at which
traffic information is produced)
has been set in the factory. It is
recommended to check this
level prior to car radio
mounting (see mounting
instructions).
Automatic selection of INFO
transmitters on FM
One of the special features of
this unit is automatic search for
and tuning of new INFO
transmitters (AUTO INFO
SEARCH).
When the radio is in the INFO
mode and the tuned INFO
transmitter has become too
weak (or when the pilot tone is
temporarily muted), the radio
will after approx 5 seconds
automatically search fora
stronger INFO transmitter and
you will hear a beep tone
(Warnton). This indication is
14
important for you if you are not
listening to the tuned
transmitter (minimum volume),
or when you are playing a
cassette.
Automatic search and tuning
takes place at two sensitivity
levels. If in the entire band no
strong transmitters are found,
a second scanning round
follows during which the radio
also tunes in to weaker INFO
transmitters. If, in exceptional
cases (like when you are
driving through a tunnel), no
weaker INFO transmitters are
being selected, anew beep
tone follows and the search
action starts all over again.
Then the INFO mode should be
switched off temporarily.
Switching on the INFO on FM
If you are listening to an FM
transmitter without traffic
information and you want a
transmitter with traffic
information, you only need to
depress the INFO button. After
5 seconds you will hear a beep
tone and the radio will
automatically tune in to the
next INFO transmitter (if
present).
CASSETTE
PLAYER
Which cassette
@ lt is strongly recommended
only to use C-60 and C-90
cassettes.
@ Use good quality cassettes.
@ Always check which type of
cassette you want to play. In
the case of a Chromium' or
'Metal' cassette, press button
(4). The word METAL will
appear on the display. in case
of a Ferro' cassette, press
button (4) once again. The
word METAL on the display will
fade.
Cassette operation controls
The cassette player is operated
by means of two buttons: the
play button (6) and the multi
function button/lever (6).
— By pressing fully the play
button () the stand-by position
is discontinued and the
cassette player is put into
play-back operation.
Furthermore, button/lever ()
may be unlocked from one of
the fast wind positions by
slightly pressing the play
button ©).
— By means of button/lever
(5), which is lockable in each
position, the following
commands may be given to the
cassette player:
1. Fast rewind: move
button/lever completely to the
left.
2. Fast forward winding: move
button/lever completely to the
right.
3. Repeating the music part
just played: move button/lever
halfway to the left (first locking
position) (MSS).