Grundig GSBS5100 Bedienungsanleitung Seite 7

Safety instructions
not keep carpets, rugs or similar
floor covers under the product. This
may cause risk of fire as a result of
inadequate ventilation!
Do not block or cover ventilation holes.
•
Otherwise, power consumption may
be increased and damage to your
product may occur.
Do not connect the product to supply
•
systems such as solar power supplies.
Otherwise, damage to your product
may occur as a result of the abrupt
voltage fluctuations!
The more refrigerant a refrigerator
•
contains, the bigger its installation
room shall be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m3 of
volume is required for each 8 grams
of refrigerant. The amount of the
refrigerant available in your product is
specified in the Type Label.
The installation place of the product
•
shall not be exposed to direct sunlight
and it shall not be in the vicinity of a
heat source such as stoves, radiators,
etc.
If you cannot prevent installation of the
product in the vicinity of a heat source,
you shall use a suitable insulation
plate and the minimum distance to
the heat source shall be as specified
below.
- At least 30 cm away from heat
sources such as stoves, heating units
and heaters, etc.,
- And at least 5 cm away from
electric ovens.
Your product has the protection
•
class of I. Plug the product in a
grounded socket that conforms with
the Voltage, Current and Frequency
values specified in the type label. The
Refrigerator / User Guide
socket outlet shall be equipped with a
fuse with a rating of 10 A – 16 A. Our
company shall not be responsible for
the damages that shall be incurred
as a result of operating the product
without ensuring ground and
electrical connections made as per
local or national regulations.
The product's power cable must
•
be unplugged during installation.
Otherwise, risk of electric shock and
injury may occur!
•
Do not plug the product to loose,
broken, dirty, greasy sockets or
sockets that has come out their
seats or sockets with a risk of water
contact.
•
Place the power cord and hoses
(if available) of the product so
that they shall not cause a risk of
tripping over.
•
Penetration of humidity to live parts
or to the power cord may cause
short circuit. Thus, do not use the
product in humid environments or
in areas where water may splash
(e.g. garage, laundry room, etc.)
If the refrigerator is wet by water,
unplug it and contact an authorized
service.
•
Do not connect your refrigerator
to power saving devices. These
systems are harmful for the
product.
1.6 Operational safety
•
Do not use chemical solvents on the
product. These materials contain an
explosion risk.
•
In case of a failure of the product,
unplug it and do not operate until it
is repaired by the authorized service.
There is a risk of electric shock!
5 / 44EN
EN
DE
FR
5