Introduction; Rating Plate; Advice On Use - Hettich Easys Bedienungsanleitung

1. Introduction

These operating instructions are intended to make it easier for
you to become familiarised with the Easys system and use it for
the purposes it is intended for.
Read the operating instructions carefully before putting the
Easys system into operation. They contain important instructions
with regard to safety, installation, operation as well as cleaning
and care.
Paul Hettich GmbH & Co. KG cannot be held responsible for
damage resulting from any failure to observe these instructions.
Keep the operating instructions in a known and easily accessible
place and pass them on to any subsequent owner.

1.1 Rating plate

The rating plate shows the following information:
Fig.: Rating plate on the Easys drive unit
Fig.: Rating plate on the power supply unit
Hettich Marketing- und Vertriebs GmbH & Co. KG · Vahrenkampstraße 12 -16 · 32278 Kirchlengern · Telefon + 49 52 23/77-0 · www.hettich.com
44
Hettich Marketing- und Vertriebs GmbH & Co. KG · Gerhard-Lüking-Straße 10 · 32602 Vlotho · Telefon +49 5733 798-0 · www.hettich.com
Abb.: Rating plate on plug-in distributor
When ordering replacement parts or making a complaint, please
specify the above data.

1.2 Advice on use

Please be careful to observe
• that the Easys System may only be used by persons (including
children) with restricted physical, sensory or mental capacity
or who lack the necessary knowledge and/or experience under
the supervision or instruction of a person responsible for their
safety.
Children should be supervised to make sure they do not play
with the tool. Easys functionality should temporarily be disa-
bled in home environments with infants aged 0-3 years.
Replacement parts are available from the kitchen manufacturer.
If you need a replacement part, please contact your retailer or
the manufacturer.
Only use genuine replacement parts from Hettich Paul Hettich
GmbH & Co. KG.
Do not make any alterations, such as additions or modifications,
to the Easys system!
Please also note that under the code of practice in electrical
engineering only qualified electricians are allowed to work on
electrical components as well as your home wiring system: