Cameo CLPFLATPRO7 Bedienungsanleitung Seite 22

SLAVE MODE
Press the MODE button repeatedly until „SLAVE MODE" appears on the display. Connect the slave and the master unit (same series) with a DMX
cable. Now the slave unit follows the master unit.
MUSIC CONTROL
Press the MODE button until „SOUND" appears in the upper line of the display. Now the projector is controlled by the built-in microphone and follows
the beat of the music. To adjust the microphone sensitivity, press ENTER, and the cursor appears in the lower line of the display (SENS:xx) and use
the UP and DOWN buttons to set the desired value from 00 to 31 (SENS:00 = minimum sensitivity, SENS:31 = maximum sensitivity). Confirm with
ENTER.
SELECTING DMX MODE
Press the MODE button repeatedly until „DMX MODE" appears in the upper line of the display. Press ENTER, and the cursor appears in the lower line
of the display and then use the UP and DOWN buttons to select one of the five DMX modes (02CH, 03CH1, 03CH2, 05CH, 08CH). Confirm with ENTER.
You will find tables with the channels of the different DMX modes on the following pages of this manual.
DMX START ADDRESS
Press the MODE button repeatedly until „DMX ADDR" appears in the upper line of the display. Press ENTER, and the cursor appears in the lower line
of the display and then use the UP and DOWN buttons to select the desired DMX start address between 001 and 512. Confirm with ENTER.
You will find tables with the channels of the different DMX modes on the following pages of this manual.
TEMPERATURE DISPLAY
Press the MODE button until "TEMPT" appears in upper line of the display. The lower line now shows the temperature of the LED unit in degrees
Celsius.
OPERATING TIME DISPLAY
Press the MODE button until "System OP. Hours" appears on the display, then press ENTER. You can now select the submenu options "Total" (total
operating time), "Show" (operating time in "Show" mode), and "Illumina" (operating time in illumination mode) via UP and DOWN, and display the
corresponding information by pressing ENTER.
SETTING THE OPERATING MODE
Press the MODE button until "Intens Config" appears on the display, then press ENTER. Now you can choose between the two modes "Show" (maxi-
mum brightness) and "Illumina" (continually reduced brightness) using the UP and DOWN buttons, and then press ENTER to confirm your selection.
Select the illumination mode to avoid brightness variations that can occur in high ambient temperatures and in "Show" mode.
22