EINHELL GCH 2000 G Originalbetriebsanleitung Seite 14

Anleitung_GCH_2000_SPK7__ 13.04.16 12:36 Seite 14
GB
11. Troubleshooting
If the equipment is operated properly you should experience no problems with malfunctions or faults. In the
event of any malfunctions or faults, please check the following before you contact your customer services.
Fault
The equipment does not heat
14
Possible cause
The power plug is not connected
The main switch is not turned on
The equipment is in standby mode
or the antifreeze function is active
The thermostat is set too low
The overheating guard has
triggered
Remedy
Connect the power plug
Turn on the main switch
Set the heat output (1000 W /
2000 W)
Increase the temperature (°C)
Note section 7.5