ChiQ BD-380WP Benutzerhandbuch Seite 6

chloride, the solid backing plates should be applied underneath the refrigerator, so as to prevent colour
change due to heat dissipation.
Unobstructed ventilation shall be maintained around the appliance or in an embedded structure.
Preparations for use
Standing time
•
After the refrigerator is properly installed and well cleaned, do not switch it on immediately. Make sure to
energize the refrigerator after more than 1 hour of standing, so as to ensure its normal operation.
Cleaning
•
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
Power-on
•
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer door, if the
temperature inside the freezer compartment drops obviously, it indicates the refrigeration system is
working normally.
Storage of food
•
After the refrigerator runs for a period of time, the internal temperature of the refrigerator will be
automatically controlled according to the user's temperature setting. After the refrigerator is fully cooled,
put in foods, which usually need 2~3 hours to be fully cooled. In summer, when the temperature is high, it
takes more than 4 hours for the foods to be fully cooled (Try to open the refrigerator door as less as
possible before the internal temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check whether the ground wire and
leakage circuit breaker are normal. If vibration noises are produced due to the refrigerator contacting the
wall or if the wall gets blackened by air convection around the compressor, move the refrigerator away from
the wall. Setting up the refrigerator may cause jamming noise or image chaos to the mobile phone, fixed-
line telephone, radio receiver, television set surrounding it, so try to keep the refrigerator as far away as
possible in such case.
Functions
Temperature setting
Function selection
CAUTION: This is a convertible refrigerator that can function either as a fridge or a freezer. Please check
whether it is set at the fridge mode or the freezer mode when powering it on.
When the refrigerator system is connected to power supply for the first time, all icons on the display panel
gets illuminated for 2s, and the system runs in the freezer mode at -18℃ by default. When all the doors are
close, the display gets extinguished automatically if no key operation within 3 minutes. When the display is
off, it will light up if any door is opened or any key is pressed.
The following key operations are valid only when the keys are unlocked and gets illuminated on the display.
Digital display
Freezer mode
Fast freezing
Alarm
Celsius degree
Fridge mode
Fast cooling
Child lock
Tennperature setting /
Switch between fridge and freezer
OK / Lock
6