Environmental Protection, Disposal - AL-KO KHS 5200 Bedienungsanleitung

Malfunctions
Switch off the log splitter and pull out the mains power plug in the event of malfunctions occurring.
Engage a specialist firm or workshop to remedy malfunctions that cannot be rectified on the basis of
the following table.
Malfunction
The log pusher does not
move out/in
The log pusher does not
exert any force
Hydraulic pump makes a
whistling noise, the log
pusher moves with
jerking motion
Motor becomes exces-
sively hot
Motor is not starting

Environmental protection, disposal

Do not dispose of old units in household waste!
The packaging, unit and accessories are made of materials that can be recycled and
should be disposed of in a suitable manner.
Cause
Too little hydraulic oil
Hydraulic pump is defective
The splitter is inclined towards the
splitting wedge
Too little hydraulic oil
The splitter is inclined towards the
splitting wedge
Too little hydraulic oil
a
The splitter is inclined towards the
splitting wedge
Air inside the circulation system
Cable cross section is too small
Thermostatic switch has switched
off
Mains plug or socket is defective
Cable is defective
Electric motor is defective
Remedy
Top up hydraulic oil
Replace hydraulic pump
Position the splitter on a horizon-
tal plane or inclined towards the
operating lever
Top up hydraulic oil
Position the splitter on a horizon-
tal plane or inclined towards the
operating lever
Top up hydraulic oil
Position the splitter on a horizon-
tal plane or inclined towards the
operating lever
Open the venting screw
Use cable with larger cross
section
Wait until the motor has cooled
down
Let an electrician check the plug
Replace
Let an electrician check the
motor
GB 5
Log splitter