Troubleshooting; Transport; Disposal - AL-KO KHS 3704 Bedienungsanleitung

Troubleshooting

TROUBLESHOOTING
If malfunctions occur, switch off the log splitter and disconnect the mains plug. Malfunctions that cannot
be rectified with reference to the following table must be rectified by an authorised specialist company.
Fault
Log pusher does not move
out/in
Log pusher has no power
Hydraulic pump whistles,
log pusher moves jerkily
Motor gets very hot
Motor does not start

TRANSPORT

CAUTION!
Do not transport the log splitter on the cy-
linder fastening.
CAUTION!
Pull out the unit plug and tighten the vent
screw prior to every change of location.
462706_i
Cause
Insufficient hydraulic oil
Hydraulic pump defective
Machine is at an angle sloping
down towards the splitter wedge
Insufficient hydraulic oil
Machine is at an angle sloping
down towards the splitter wedge
Insufficient hydraulic oil
Machine is at an angle sloping
down towards the splitter wedge
Air in the circuit
Cable cross-section too small
Thermal switch has switched off
Mains plug or socket defective
Cable defective
Electric motor defective
Solution
Refill hydraulic oil
Renew hydraulic pump
Set the machine horizontal or slo-
ping down towards the operating
lever
Refill hydraulic oil
Set the machine horizontal or slo-
ping down towards the operating
lever
Refill hydraulic oil
Set the machine horizontal or slo-
ping down towards the operating
lever
Open the vent screw
Use a cable with a larger cross-
section
Wait until the motor has cooled
down.
Have a check performed by an
electrician
Renew
Have a check performed by an
electrician
Hold the log splitter on the transport bracket
to transport

DISPOSAL

Do not dispose of worn-out machines
or spent batteries (including recharge-
able batteries) in domestic waste!
The packaging, machine and accessories
are made from recyclable materials and
must be disposed of accordingly.
19