Initial Configuration - EHEIM autofeeder+ 3583 Bedienungsanleitung

English

Initial configuration

6. Select the desired language from the language selection and follow the instructions for the initial configuration.
Meaning of the status LED
‧ The status LED flashes white: The network is being searched for or created
‧ The status LED illuminates blue: The automatic feeder is in master mode
‧ The status LED illuminates green: The automatic feeder is connected to another EHEIM digital device
Reset
1. Press the touch panel ⑫ for approx. 8 – 10 seconds until the status LED ⑬ lights up and changes colour.
‧ When the status LED lights up green, the reset is complete. The automatic feeder restores the network.
‧ The network security key and QR code 1 are invalid. The network can be connected to without the network
security key
Setting the feed quantity (⌦G/H)
1. Set the desired feed quantity using the slider ⑪ on the drum unit.
2. Start a manual feed to check the feed quantity. Place your finger on the touch panel ⑫ for 1-2 seconds until
the status LED ⑬ flashes.
Place a white sheet of paper underneath to determine the feed quantity.
Operation without WLAN connection
1. Insert the power supply unit in the mains socket.
2. Actuate the touch panel.
The feed drum will rotate 1x and then again automatically at the same time every 24 hours.
If the touch panel is actuated for a second time within a minute, 2 feedings will then be given at the same time
every 24 hours.
To delete the programmed time and number of rotations, place your finger on the touch panel for longer than
approx. 10 seconds until the status LED illuminates in all the colours of the rainbow.
23