EHEIM autofeeder+ 3583 Bedienungsanleitung Seite 21

English
‧ Protect the mains socket and mains plug against moisture and wetness. A drip loop
must be formed with the mains cable. This prevents any water running along the cable
to the mains socket, which would result in a short-circuit.
‧ The electrical data of the power supply unit must match the data of the power mains.
This data is found on the type plate, the packaging and in these instructions.
‧ Only use the power supply unit that has been supplied with the appliance. If it needs to
be replaced, then an original EHEIM power supply unit has to be used.
Commissioning
Installing the automatic feeder (⌦A/B)
1. Connect the drum unit ② to the drive unit ①.
2. Connect the plug ④ of the power supply unit to the socket ③ on the underside of the drive unit.
Installing the automatic feeder – aquariums with covers (⌦C)
‧ In order to prevent the feed from clumping due to the damp air being blown in, the automatic feeder must not
be installed underneath the aquarium cover.
‧ Use a flat part of the aquarium cover to install the automatic feeder; this will ensure that the feed can easily
reach the water's surface.
1. Remove the protective film from the Velcro securing point ⑤.
2. Place the automatic feeder on the aquarium cover.
Installing the automatic feeder – open aquariums (⌦D/E)
1. Fasten the terminal ⑦ by turning the plastic nut ⑧ on the leading edge of your aquarium.
2. Place the plate ⑥ in the correct position on the terminal.
3. Remove the protective film from the Velcro securing point ⑤.
4. Place the automatic feeder on the plate.
Filling the feed drum (⌦F)
1. Remove the drum unit from the drive unit.
2. Remove the cover ⑨ from the feed drum ⑩.
21
Drip Loop