Inhaltsverzeichnis
Werbung
G
Replace the Hydraulic oil in the log splitter after
14
ack and
every 150 hours of use. Take following steps to
position,
replace it.
jammed
Make sure all moving parts stops and the log
e wedge
splitter is unplugged.
Unscrew Oil Drain Bolt with Dipstick to remove
jammed
it.
Turn the log splitter on the Support Leg side
sharper
over an 4 liters capacity container to drain the
log is
hydraulic oil off.
Turn the log splitter on the the motor side.
Refill fresh hydraulic oil at the volume as per the
hydraulic oil capacity of a particular model
indicated in above specifications table.
Clean the surface of Dipstick on the Oil Drain
Bolt and put it back into the oil tank while keep
the log splitter vertically.
log off.
Make sure the level of the refilled oil is just
machine
between 2 grooves around the Dipstick.
cause
Clean the Oil Drain Bolt before thread them
back. Make sure they are tightened to avoid
leakage before place the log splitter horizontally.
Periodically check oil level to ensure it is
between 2 grooves around the Dipstick. Upon
Lower oil level, oil refilling is required.
Following hydraulic oils or equivalent are recommend for the log splitter's hydraulic
transmission system:
SHELL Tellus 22
MOBIL DTE 11
9
ARAL Vitam GF 22
BP Energol HLP-HM 22
SHARPENING WEDGE
After using the log splitters for some time, sharpen the wedge of the log splitter using a
fine-toothed file and smooth any burrs or crushed area along the cutting edge.
TROUBLE SHOOTING
PROBLEM
14 / 36
PROBABLE CAUSE
11
15
REMEDY SUGGESTED
Werbung
Inhaltsverzeichnis
